Manual Call Point MS Body
Categories
- Aspiration system (0)
- Control Relay Modules (0)
- Corresponding Signal Indicator (1)
- Detection-Devices (0)
- Addressable Beam Detector (0)
- Addressable Optical Smoke Detector (0)
- Addressable Photothermal Detector (0)
- Addressable ROR cum fixed temperature (0)
- Conventional Sensors Series (0)
- Duct Smoke Sampling Detector (0)
- Heat Detector (0)
- Industrial Heat Detector (0)
- Intelligent Addressable Sensors (0)
- Multi Detector (0)
- Smoke Detector (0)
- Direct Release Clean Agent (0)
- Emergency / Notification Voice Announcement (1)
- Emergency Voice Communication System (0)
- Fire Alarm Accessories (21)
- Fire Alarm Control Panels (13)
- Conventional Fire Alarm Series (0)
- Intelligent Addressable Panel's (0)
- 1 Loop Addressable Fire Alarm Control Panel (0)
- 10 Loop Addressable Fire Alarm Control Panel (0)
- 2 Loop Addressable Fire Alarm Control Panel (0)
- 4 Loop Addressable Fire Alarm Control Panel (0)
- Backnet/ModBus Card (0)
- Handheld Programmer for Addressing of Addressable devices (0)
- Intelligent Addressable Fire Alarm Accessories (0)
- Repeater Panels (0)
- RS-232 Communication Card (0)
- RS-485 Network communication card (0)
- Software (0)
- Fire Safety (1)
- Gas Suppression System (0)
- GOVT. OF INDIA CPWD DSR (0)
- Linear Heat Detection (0)
- Notification Alarm Devices (0)
- PA System (0)
- Safety & Directional Signage (0)
- Signaling Devices (1)
- Uncategorized (1)
- UTC/GST (4)
- Water Leakage Detection System (0)
Showing the single result

Agni, Manual Call Point MS Body
AGNI-301
Conventional manual call point is an emergency alerting device which can be activated by pressing a transparent plastic window on its front side. The call point once activated can be reset by using a key with the device. Designed for use with conventional fire alarm control panels and alarm loop by installing the module conventional zone module. This allows the fire alarm control panel to monitor the conventional call point
devices.