Agni Veiga Series
-
Aspiration system - Control Relay Modules
- Corresponding Signal Indicator
- Detection Devices
- Direct Release Clean Agent
- Emergency / Notification Voice Announcement
- Emergency Voice Communication System
- Equipment Rack
- Fire Alarm Accessories
- Fire Alarm Control Panels
- Conventional Fire Alarm Series
- Intelligent Addressable Panel's
- 1 Loop Addressable Fire Alarm Control Panel
- 10 Loop Addressable Fire Alarm Control Panel
- 2 Loop Addressable Fire Alarm Control Panel
- 4 Loop Addressable Fire Alarm Control Panel
- Backnet/ModBus Card
- Handheld Programmer for Addressing of Addressable devices
- Intelligent Addressable Fire Alarm Accessories
- Repeater Panels
- RS-232 Communication Card
- RS-485 Network communication card
- Software
-
-
- Fire Safety
- Gas Suppression System
- GOVT. OF INDIA CPWD DSR
- Hooter/Hooter Flasher/Hooter cum Speaker
- Linear Heat Detection
- Notification Alarm Devices
- PA System
- Safety & Directional Signage
- Signaling Devices
- Uncategorized
- UTC/GST
- Water Leakage Detection System
Agni Veiga Handheld Programming Unit – ALPU1000
The Agni Veiga Handheld Programming Unit is a portable, battery-powered device designed to read, configure, and program parameters of Agni Veiga analogue addressable devices. Programming and diagnostic unit for Agni Veiga analogue addressable devices. Enables address setting, parameter configuration, firmware reading, and device diagnostics using an in-built keypad and display.Â
Agni Veiga Intelligent Addressable Detector Mounting Standard Base
The Detector Mounting Standard Base is a durable mounting solution for Agni Veiga Series intelligent addressable detectors, designed for secure ceiling installation, easy wiring, and reliable detector locking.
Agni Veiga Intelligent Addressable Series Zone Monitor Module (IND-VMCZ100)
A Zone Monitor Module is an interface device that connects and supervises non-addressable (conventional) detectors or third-party input devices using standardized @ resistor values. It provides continuous monitoring for alarm, open-circuit, and short-circuit conditions and reports these states digitally to an addressable fire alarm control panel. Each module has a dedicated digital address for identification.
Agni Veiga Series Intelligent Addressable BACnet / Modbus Communication Card
The Agni Veiga Series Intelligent Addressable BACnet / Modbus Communication Card enables seamless integration between Agni fire alarm control panels and external Building Management Systems (BMS), SCADA, or PLC platforms.
It converts proprietary fire panel data into standard Modbus RTU (RS-485) or TCP/IP, allowing real-time monitoring of alarms, faults, zones, and device statuses through third-party systems.Â
Agni Veiga Series Intelligent Addressable Control Module
An intelligent addressable control module assigned acts as a smart intermediary for third-party systems actions for other buildings relevant, like shutting off HVAC, recalling elevators, or activating horns/strobes, and vice versa, integrating diverse devices into an addressable system for enhanced safety and coordinated response during a fire.
Agni Veiga Series Intelligent Addressable Manual Call Point
The Agni Veiga Intelligent Addressable Manual Call Point is a well infallible fire alarm activation device designed for fast response, high visibility, and built in fault isolator with intelligent fire alarm control panels using Agni’s fully digital protocol.Â
Agni Veiga Series Intelligent Addressable RS-485 Network Communication Card
The Agni Veiga Series Network Communication Card (FAP-3002) is a robust RS485-based intelligent addressable communication module designed for multi-panel networking in fire alarm systems. It enables long-distance, fault-tolerant data communication between control panels, repeaters, and network devices with high noise immunity and reliable performance.Â
